HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 49)

HEIDENHAIN iTNC 530 49
1.
2
A
vailable
cy
cle
gr
oups
1.2 Available cycle groups
Overview of fixed cycles
 The soft-key row shows the available groups of
cycles
 If required, switch to machine-specific fixed cycles.
These fixed cycles can be integrated by your machine
tool builder.
Cycle group Soft key Page
Cycles for pecking, reaming, boring, and counterboring Page 76
Cycles for tapping, thread cutting and thread milling Page 110
Cycles for milling pockets, studs and slots Page 144
Cycles for producing point patterns, such as circular or linear hole patterns Page 176
SL (Subcontour List) cycles which allow the contour-parallel machining of relatively complex
contours consisting of several overlapping subcontours, cylinder surface interpolation
Page 188
Cycles for multipass milling of flat or twisted surfaces Page 260
Coordinate transformation cycles which enable datum shift, rotation, mirror image, enlarging and
reducing for various contours
Page 278
Special cycles such as dwell time, program call, oriented spindle stop, tolerance, engraving and
interpolation turning (option)
Page 308