HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 490)

490 Touch probe cycles: automatic kinematics measurement
18
.4
MEA
S
URE
KINEMA
TICS
(Cy
cle
451,
DIN/ISO:
G451;
Option)
 Feed rate for pre-positioning
Q253: Traversing
speed of the tool during positioning in mm/min. Input
range 0.0001 to 99999.9999; alternatively FMAX,
FAUTO
, PREDEF
 Reference angle Q380 (absolute): Reference angle
(basic rotation) for measuring the measuring points in
the active workpiece coordinate system. Defining a
reference angle can considerably enlarge the
measuring range of an axis. Input range 0 to 360.0000
 Start angle A axis
Q411 (absolute): Starting angle in
the A axis at which the first measurement is to be
made. Input range -359.999 to 359.999
 End angle A axis
Q412 (absolute): Ending angle in the
A axis at which the last measurement is to be made.
Input range -359.999 to 359.999
 Angle of incid. A axis
Q413: Angle of incidence in
the A axis at which the other rotary axes are to be
measured. Input range -359.999 to 359.999
 Number meas. points A axis Q414: Number of probe
measurements with which the TNC is to measure the
A axis. If the input value = 0, the TNC does not
measure the respective axis. Input range 0 to 12
 Start angle B axis
Q415 (absolute): Starting angle in
the B axis at which the first measurement is to be
made. Input range -359.999 to 359.999
 End angle B axis
Q416 (absolute): Ending angle in the
B axis at which the last measurement is to be made.
Input range -359.999 to 359.999
 Angle of incid. in B axis Q417: Angle of incidence
in the B axis at which the other rotary axes are to be
measured. Input range -359.999 to 359.999
 Number meas. points B axis Q418: Number of probe
measurements with which the TNC is to measure the
B axis. If the input value = 0, the TNC does not
measure the respective axis. Input range 0 to 12