HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 72)

72 Using fixed cycles
2.4
Point
tables
Hiding single points from the machining process
In the FADE column of the point table you can specify if the defined
point is to be hidden during the machining process.
In the table, select the point to be hidden.
Select the FADE column.
Activate hiding, or
Deactivate hiding.
Defining the clearance height
In the CLEARANCE column you can define a separate height for every
point. The TNC then positions the tool to this value in the tool axis
before you reach this position in the working plane (see also "Calling a
cycle in connection with point tables" on page 74).
To hide the marked point during machining, you must also
set the Block skip soft key to ON in the Program Run
operating mode.