HEIDENHAIN ND 2100G - Manual (Page 85)

ND 2100G GAGE-CHEK 85
2
.3
S
o
ft
wa
re
s
e
tu
p Nominal values with tolerances
Nominal values with tolerances can be specified as a nominal value
between +/- tolerances, or as a nominal value with ++/- - tolerances
distributed entirely on the plus side or entirely on the minus side of the
nominal value.
Nominal with +/- tolerances
A nominal value is displayed between plus and minus tolerances.
To specify a nominal value with +/- tolerances:
U Highlight the Dimension field
U Press the +/- soft key to specify a nominal value with +/- tolerances
U Highlight the desired tolerance field
U Enter the desired tolerance value
U Press the ENTER key
U Repeat until all tolerances are entered
This example screen contains the nominal value and tolerances listed
below:
„ Nominal = 3.0000 mm
„ Warning tolerance = ± 0.050 mm
„ Limit tolerance = ± 0.060 mm
„ Max tolerance = ± 0.080 mm
0.08 Nom + Max
0.06 Nom + Limit
0.05 Nom + Warning
3 mm nominal
-0.05 Nom - Warning
-0.06 Nom - Limit
-0.08 Nom - Min
Nominal and +/- tolerances for dimension A.
Values specified using the +/- Tolerances setup screen will
also be converted to fixed limits if the Limits soft key is
pressed.
Acceptable
range of
values