HEIDENHAIN ND 2100G - Manual (Page 38)

38 1 Operation
1
.4 LCD scr
eens and menus
The Extra menu functions
The Extra menu provides quick access to a variety of display and other
system functions. To use any Extra menu function, highlight the
desired function, and then press the ENTER key.
EXTRA menu functions.
Extra menu
functions Function
Cycle Advances to the next defined part. Part
numbers are cycled in a continuous loop.
DMS/DD Toggles the display of angles between
Degrees, Minutes, Seconds (DMS) and
Decimal Degrees (DD).
Fast3 Refer to "Fast3" on page 39.
Hold Toggle function that holds (freezes) or
releases the current value of a single
dimension when a dimension soft key is
pressed, or of all dimensions when the ALL
soft key is pressed.
Part? Displays a pop-up screen that allows the user
to specify a new part number.
Rad/Dia Toggles between the radius and diameter
measurement types on the DRO screen, if
radius or diameter was specified in the
Formats setup screen.
Recall Applies the last used incremental datum (D1)
preset that was entered by the user.
RsetDyn Resets the minimum and maximum values
accumulated during dynamic measurements.
This function must be initiated prior to new
dynamic measurements.
Send Sends the specified current dimension
values, or all current dimension values to the
RS-232 serial port for transmission to a
computer. The user is prompted to send one
or all.
SendRec Sends stored records to the RS-232 serial
port for transmission to a computer. Refer to
"Report setup screen" on page 127.