HEIDENHAIN ND 2100G - Manual (Page 137)

ND 2100G GAGE-CHEK 137
2
.3
S
o
ft
wa
re
s
e
tu
p Stop bits
The Stop Bits field is used to specify the number of stop bits included
after each data word.
To specify stop bits:
U Highlight the Stop Bits field
U Press the 1 or 2 soft key to specify the number of stop bits
U Press the ENTER key
Parity
The Parity field is used to specify odd or even parity for error checking,
or to omit parity error checking.
To specify parity:
U Highlight the Parity field
U Press the NONE, ODD or EVEN soft key to specify parity error
checking parameters
U Press the ENTER key
Handshaking
The Handshake field shows the type of synchronous signaling used by
the system to prevent data collisions on the serial port. This is set to
hardware and cannot be changed.
End of character (EOC) delay
The EOC delay field is used to specify the delay inserted after each
character is transmitted. This delay can be increased or decreased to
accommodate various serial devices.
To specify EOC delay:
U Highlight the EOC Delay field
U Use the numeric keypad to specify delays (in milliseconds) from 0 to
10 seconds between characters
U Press the ENTER key