HEIDENHAIN ND 2100G - Manual (Page 209)

ND 2100G GAGE-CHEK 209
2.4 F
o
rm
ulas
To accomplish this sequence of measurements using only one
channel, the operator performs the following steps from the beginning
of the sequence:
U Position the block and channel input to measure height (H)
U Press the ENTER key to store the channel value. The ND 2100G
advances to the next step in the sequence.
H = seq(1,C1)
U Position the block and channel input to measure width (W)
U Press the ENTER key to store the new channel value. The
ND 2100G advances to the next step in the sequence.
W = seq(2,C1)