Connecting a computer, Connecting headphones and usb printer, Connecting headphones – HEIDENHAIN ND 2100G User Manual
Page 66: Connecting a usb printer
66
2 Installation and Specifications
2.2 Har
d
w
a
re
Installation
Connecting a computer
Measurement result data can be sent to a computer over the RS-232
port (
1
) using a serial cable that does not include crossed wires.
To connect a computer:
U
Verify that the ND 2100G and the computer power are off
U
Connect a computer COM port to the ND 2100G RS-232 serial port
(
1
) using a standard straight-through serial cable. Make sure the
cable connectors are tight, but do not overtighten the connector
screws.
U
Apply power to the computer, and then the ND 2100G. The
ND 2100G default settings for communication over the RS-232
serial port (
1
) are:
U
Launch the computer application that will be used to communicate
with the ND 2100G, and configure the communication properties of
the COM port to match those of the ND 2100G
Connecting headphones and USB printer
Connecting headphones
Audio alerts can be sent to headphones in areas that are noisy and
make it difficult to hear, or are quiet where audio alerts might create a
disturbance.
The speaker jack (
1
) is located on the side of the ND 2100G.
To connect headphones:
U
Verify that the ND 2100G power is off. Plug the headphones into the
speaker jack (
1
) on the side of the enclosure.
U
Make sure the headphone plug is fully inserted
Connecting a USB printer
The ND 2100G supports certain USB printers. Printer models are
specified by HEIDENHAIN at the time of purchase, or approved by
HEIDENHAIN later.
The USB port (
2
) is located on the side of the ND 2100G.
To connect the USB printer:
U
Verify that the ND 2100G and printer power are off. Connect the
USB printer to the USB Type A port (
2
) on the side of the enclosure.
U
Make sure the USB cable plug is fully inserted
RS-232 connector.
1
Baud rate
115,200
Word length
8 bits
Stop bits
1 bit
Parity
None
Headphone and USB connectors.
1
2