HEIDENHAIN ND 2100G - Manual (Page 123)

ND 2100G GAGE-CHEK 123
2
.3
S
o
ft
wa
re
s
e
tu
p Enable SLEC
When all station data for the encoder has been entered, the SLEC
function must be enabled.
To enable SLEC:
U Highlight the Enabled field for any channel
U Press the ON soft key to enable SLEC or LEC for that channel
Display setup screen
The Display setup screen contains fields for configuring LCD display
parameters.
Radix for numeric displays
The Radix field is used to specify the radix displayed in numeric fields.
To specify the radix:
U Highlight the Radix field
U Press the DECIMAL or COMMA soft key
U Press the ENTER key
Display mode for angles
The Current Angular field is used to specify the display mode for
angles until system power is cycled. When power is cycled, the start-
up angular setting will be used to define the display of angles. Current
angular displays of measured angles can be set to decimal degrees
(DD) or to degrees, minutes and seconds (DMS).
To specify Current Angular settings:
U Highlight the Current Angular field
U Press the DD or DMS soft key
U Press the ENTER key
Clear all
Datums Cycle Power &
Set Machine 0 Clear Old
Values &
Disable SLEC Enter
Machine 0
Offset Enter New
Station
Values Enable SLEC
Display setup screen.