HEIDENHAIN ND 2100G - Manual (Page 119)

ND 2100G GAGE-CHEK 119
2
.3
S
o
ft
wa
re
s
e
tu
p Cycle power & set machine zero
The following steps cycle power to reestablish fresh machine zeros
for all input channels.
To cycle power and set machine zeros:
U Turn the ND 2100G power switch off, wait for a few seconds and
turn the power switch on again
U Press the FINISH or QUIT key to initiate the ND 2100G display
You will be prompted to move the encoder to cross reference marks
or perform hard stop zeroing on all input channels.
U Perform machine zero operations on all channels
Clear all
Datums Cycle Power &
Set Machine 0 Clear Old
Values &
Disable SLEC Enter
Machine 0
Offset Enter New
Station
Values Enable SLEC
Reference marks must be specified in the Channels setup
screen to establish a machine zero on startup.
If a hard stop zero is performed, the same stop will be
required each time the ND 2100G is started.