HEIDENHAIN ND 2100G - Manual (Page 124)

124 2 Installation and Specifications
2
.3
S
o
ft
wa
re
s
e
tu
p Startup angular and linear display modes
The Startup Angular and Startup Linear fields are used to specify the
default display of angular and linear measurements when power is
applied to the system. These display settings can be changed
temporarily but will revert to the startup defaults unless the Last
setting is selected. The Last setting can be selected to start the
system using the last units that were active at shutdown.
Linear measurements can be displayed in English or metric units of
measure. Angular measurements can be displayed in degrees,
minutes and seconds or in decimal degrees.
To specify Startup Linear settings:
U Highlight the Startup Linear field
U Press the MM, INCH or LAST soft key
U Press the ENTER key
To specify Startup Angular settings:
U Highlight the Startup Angular field
U Press the DD, DMS or LAST soft key
U Press the ENTER key