HEIDENHAIN ND 2100G - Manual (Page 100)

100 2 Installation and Specifications
2
.3
S
o
ft
wa
re
s
e
tu
p Selecting the channel input type
Channel input devices are attached to standard interface connectors
or to an RS-232 serial port on the rear of the ND 2100G. The number
and type of channel inputs are specified when the ND 2100G is
purchased, but might need to be specified again in the field.
To select the channel input type:
U Highlight the Type field
U Press the LIST soft key to display the list of channel input types
U Use the UP and DOWN ARROW cursor keys to highlight the desired
input channel type and press the ENTER key
Input type Description
TTL TTL square wave encoder
Analog Sinusoidal analog encoder
D1311 RS-232 thermocouple
HBT Analog input from half-bridge transducers
LVDT Analog input from full-bridge transducers
Albion RS-232 temperature compensation for gage
materials
A2D Analog input from a wide variety of analog to digital
devices
A2E Analog input from air gage devices
AEK Analog input from AEK air gage devices
SerAxis RS-232 Single probe input to primary or secondary
RS-232 port
MTISer Data byte inputs from single MTI probes
D5451 RS-232 serial thermocouple probe network
Orbit RS-232 Solartron Orbit probe network
Marposs RS-232 serial probe network
SonyMG RS-232 Sony probe network
DMX RS-232 multiplexer
MPLX RS-232 multiplexer
Micro II RS-232 interface
Endat Lin EnDat linear encoder
Endat Rot EnDat rotary encoder
AccuScan RS-232 laser scanning interface