HEIDENHAIN ND 2100G - Manual (Page 77)

ND 2100G GAGE-CHEK 77
2
.3
S
o
ft
wa
re
s
e
tu
p Dimensions setup screen
The Dimensions setup screen contains fields for defining the part and
dimension labels displayed on the screen, included in transmitted
data, printed on reports and stored in the ND 2100G database for up
to 100 individual parts. Dimensions must be defined prior to other
setup activities and conducting tests.
Part numbers consist of up to 2 numeric digits in the range from 0 to
99 entered by the system in sequence as new parts are added. Part
and dimension labels consist of up to 8 alphanumeric characters
entered from the character entry screen and the numeric keypad. Part
names are shown in reports, but only part numbers are shown in
formulas. Completed dimension labels of one part can be copied and
applied to another.
Creating part numbers
Up to 100 (software) parts can be created in the ND 2100G. Multiple
parts are useful when the number of measurements performed on
one physical part is large and could be divided into categories, or when
different physical parts must be measured.
To create a new part number:
U Highlight the Part field
U Press the NEW soft key
Selecting part numbers
To select an existing part number:
U Press the LEFT WIDE key or the DEC soft key to navigate down
through a list of parts
or
U Press the RIGHT WIDE key or the INC soft key to navigate up
through a list of parts
Dimensions setup screen.
Deleting part numbers will erase any data associated with
the part’s dimensions in the ND 2100G database. Deleting
a part number also decrements the part numbers of any
higher numbered parts. This will cause data for a part
number to be different as it now contain data from a
previously higher numbered part.