Delta Electronics AC Motor Drive VFD-E User Manual
Delta Electronics Tools
Table of contents
Document Outline
- Preface
- Table of Contents
- Chapter 1 Introduction
- 1.1 Receiving and Inspection
- 1.2 Preparation for Installation and Wiring
- 1.3 Dimensions
- Chapter 2 Installation and Wiring
- Chapter 3 Keypad and Start Up
- Chapter 4 Parameters
- Chapter 5 Troubleshooting
- 5.1 Over Current (OC)
- 5.2 Ground Fault
- 5.3 Over Voltage (OV)
- 5.4 Low Voltage (Lv)
- 5.5 Over Heat (OH)
- 5.6 Overload
- 5.7 Keypad Display is Abnormal
- 5.8 Phase Loss (PHL)
- 5.9 Motor cannot Run
- 5.10 Motor Speed cannot be Changed
- 5.11 Motor Stalls during Acceleration
- 5.12 The Motor does not Run as Expected
- 5.13 Electromagnetic/Induction Noise
- 5.14 Environmental Condition
- 5.15 Affecting Other Machines
- Chapter 6 Fault Code Information and Maintenance
- Appendix A Specifications
- Appendix B Accessories
- B.1 All Brake Resistors & Brake Units Used in AC Motor Drives
- B.2 No-fuse Circuit Breaker Chart
- B.3 Fuse Specification Chart
- B.4 AC Reactor
- B.5 Zero Phase Reactor (RF220X00A)
- B.6 Remote Controller RC-01
- B.7 PU06
- B.8 KPE-LE02
- B.9 Extension Card
- B.10 Fieldbus Modules
- B.11 DIN Rail
- Appendix C How to Select the Right AC Motor Drive
- Appendix D How to Use PLC Function
- D.1 PLC Overview
- D.2 Start-up
- D.3 Ladder Diagram
- D.4 PLC Devices
- D.4.1 Summary of DVP-PLC Device Number
- D.4.2 Devices Functions
- D.4.3 Value, Constant [K] / [H]
- D.4.4 The Function of Auxiliary Relay
- D.4.5 The Function of Timer
- D.4.6 The Features and Functions of Counter
- D.4.7 Register Types
- D.4.8 Special Auxiliary Relays
- D.4.9 Special Registers
- D.4.10 Communication Addresses for Devices (only for PLC2 mode)
- D.4.11 Function Code (only for PLC2 mode)
- D.5 Commands
- D.5.1 Basic Commands
- D.5.2 Output Commands
- D.5.3 Timer and Counters
- D.5.4 Main Control Commands
- D.5.5 Rising-edge/falling-edge Detection Commands of Contact
- D.5.6 Rising-edge/falling-edge Output Commands
- D.5.7 End Command
- D.5.8 Explanation for the Commands
- D.5.9 Description of the Application Commands
- D.5.10 Explanation for the Application Commands
- D.5.11 Special Application Commands for the AC Motor Drive
- D.6 Error Code
- Appendix E CANopen Function