beautypg.com

21 factory default – Interlogix NS3550-8T-2S User Manual User Manual

Page 71

background image

71

4.2.21 Factory Default

You can reset the configuration of the stack switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in

Figure 4-2-32

appears.

Figure 4-2-32:

Factory Default Page Screenshot

Buttons

: Click to reset the configuration to Factory Defaults.

Figure 4-2-33:

Factory Default Page Screenshot

: Click to return to the web main page without resetting the configuration.

After the “Factory” button ispressed and rebooted, the system will load the default IP settings as following:

Default IP address: 192.168.0.100

Subnet mask: 255.255.255.0

Default Gateway: 192.168.0.254

The other setting value is back to disable or none.

To reset the Industrial Managed Switch to the Factory default setting, you can also press the hardware
reset button at the front panel for more than 10 seconds. After the device is rebooted, you can login the
management WEB interface within the same subnet of 192.168.0.xx.