Interlogix NS3550-8T-2S User Manual - Manual (Page 291)

User’s Manual of NS3550-8T-2S
291
4.18.2 PTP Status
This section allows the user to inspect the current Precision Time Protocol (PTP) clock settings.
Figure 4-18-3: PTP Clock Status page screenshot
The page includes the following fields:
Object Description
 One_pps_mode Shows the current One_pps_mode configured.
1. Output : Enable the 1 pps clock output
2. Input : Enable the 1 pps clock input
3. Disable : Disable the 1 pps clock in/out-put
 External Enable Shows the current External clock output configuration.
1. True : Enable the external clock output
2. False : Disable the external clock output
 VCXO_Enable Shows the current VCXO rate adjustment configuration.
1. True : Enable the external VCXO rate adjustment
2. False : Disable the external VCXO rate adjustment
 Clock Frequency Shows the current clock frequency used by the External Clock.
The possible range of values are 1 - 25000000 (1 - 25MHz)
 Clock Instance Indicates the Instance of a particular Clock Instance [0..3].
Click on the Clock Instance number to monitor the Clock details
 Device Type Indicates the Type of the Clock Instance. There are five Device Types.
1. Ord-Bound - Clock's Device Type is Ordinary-Boundary Clock.
2. P2p Transp - Clock's Device Type is Peer to Peer Transparent Clock.
3. E2e Transp - Clock's Device Type is End to End Transparent Clock.
4. Master Only - Clock's Device Type is Master Only.
5. Slave Only - Clock's Device Type is Slave Only.
 Port List Shows the ports configured for that Clock Instance.
Buttons
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs every 6 seconds.
: Click to refresh the page immediately.