Interlogix NS3550-8T-2S User Manual - Manual (Page 472)

User’s Manual of NS3550-8T-2S
472
In a unicast Slave only clock you also need configure which master clocks to request Announce and
Sync messages from. See command UniConfig
: The oneway parameter takes the following values:
true : The clock slave uses one-way measurements, i.e. no delay requests
false : The clock slave uses two-way measurements
: 8 byte clock identity( xx:xx:xx:xx:xx:xx:xx:xx)
: The tag_enable parameter takes the following values:
true : The ptp frames are tagged with the VLAN tag specified in the VID field.
Note : Packets are only tagged if the port is configured for vlan tagging. i.e:
Port Type != Unaware and PortVLAN mode == None.
false : The ptp frames are sent untagged.
: The VID parameter takes the following values:
0 - 4095 : The range of VID's ptp can use to send tagged frames
: The Prio parameter takes the following values:
0 - 7: The range of Priorities ptp can use in the tagged frames
PTP ClockDelete
Description:
Delete a PTP clock instance.
Syntax:
PTP ClockDelete []
Parameters:
: clock instance number [0..3]
: The devtype parameter takes the following values:
ord : Ordinary/Boundary clock
p2p : Peer-to-peer transparent clock
e2e : End-to-end transparent clock
mst : Master only clock
slv : Slave only clock
(default : Show actual init parameters)
PTP DefaultDS
Description:
Set or show PTP clock Default Data set priority1 and priority2 are used in the best master clock algorithm. Lower values
take precedence.
Syntax:
PTP DefaultDS [] [] []
Parameters:
: clock instance number [0..3]
: [0..255] Clock priority 1 for PTP BMC algorithm
: [0..255] Clock Priority 2 for PTP BMC algorithm
: [0..127] PTP clock domain id (0 = default) for PTP