beautypg.com

Interlogix NS3550-8T-2S User Manual User Manual

Page 112

background image

User’s Manual of NS3550-8T-2S

112

For this example, just set VLAN Group 1 as default VLAN, but only focus on VLAN 2 and VLAN 3
traffic flow

Setup steps

1. Create

VLAN

Group

Set VLAN Group 1 = Default-VLAN with VID (VLAN ID) =1
Add two VLANs – VLAN 2 and VLAN 3

VLAN Group 2 with VID=2
VLAN Group 3 with VID=3

2. Assign VLAN Member :

VLAN 2 : Port-1,Port-2 and Port-3
VLAN 3 : Port-4, Port-5 and Port-6
VLAN 1 : All other ports – Port-7~Port-24

3. Remove VLAN Member for VLAN 1:

Remember to remove Port 1 – Port 6 from VLAN 1 membership, since Port 1 – Port 6 have been assigned to VLAN 2 and
VLAN 3.

Figure 4-6-9:

Add new VLAN group, assign VLAN members to VLAN 2 and VLAN 3 and remove specifed ports from VLAN1

member

It’s important to remove the VLAN members from VLAN 1 configuration. Or the ports would become
overlap setting. ( About the overlapped VLAN configuration, see next VLAN configure sample)

4. Assign PVID to each port:

Port-1,Port-2 and Port-3 : PVID=2
Port-4,Port-5 and Port-6 : PVID=3
Port-7~Port-24 : PVID=1

5. Enable VLAN Tag for specific ports

Link Type: Port-3 (VLAN-2) and Port-6 (VLAN-3)

The Per Port VLAN configuration in

Figure 4-6-10

appears.