Interlogix NS3550-8T-2S User Manual - Manual (Page 462)

User’s Manual of NS3550-8T-2S
462
MEP Continuity Check Configuration
Description:
MEP Continuity Check configuration
'prio' is the priority (PCP) of transmitted CCM frame
'300s|100s|10s|1s|6m|1m|6h' is the number of CCM frame pr. second.
Syntax:
MEP cc config [] [] [300s|100s|10s|1s|6m|1m|6h] [enable|disable]
Parameters:
: Instance number
: OAM PDU priority
300s|100s|10s|1s|6m|1m|6h : OAM period (100s -> 100 PDU pr. second)
enable|disable : enable/disable
MEP Loss Measurement Configuration
Description:
MEP Loss Measurement configuration
'prio' is the priority (PCP) of transmitted LM frame
'uni|multi' is selecting uni-cast or multi-cast transmission of LM frame
'single|dual' is selecting single-ended (LMM) or dual-ended (CCM) LM
'10s|1s|6m|1m|6h' is the number of LM frame pr. second
'flr' is the Frame Loss Ratio time interval.
Syntax:
MEP lm config [] [] [uni|multi] [single|dual] [10s|1s|6m|1m|6h] [] [enable|disable]
Parameters:
: Instance number
: OAM PDU priority
uni|multi : Destination address is unicast or multicast
single|dual : LM is single or dual ended
10s|1s|6m|1m|6h : LM period (10s -> 10 PDU pr. second)
: Frame loss ratio (in sec.)
enable|disable : enable/disable
MEP APS Configuration
Description:
MEP APS configuration
'prio' is the priority (PCP) of transmitted APS frame
'uni|multi' is selecting uni-cast or multi-cast transmission of APS frame
'laps|raps' is selecting ELPS or ERPS protocol
'octet' is the last octet in RAPS multicast MAC.
Syntax:
MEP aps config [] [] [uni|multi] [laps|raps] [] [enable|disable]
Parameters:
: Instance number
: OAM PDU priority
uni|multi : Destination address is unicast or multicast
laps|raps : Selection of Linear or Ring APS type
: The last octet in RAPS multicast MAC
enable|disable : enable/disable
MEP Client Configuration
Description:
MEP Client configuration
'domport|domevc' is the client domain - must be EVC
'level' is the client MEG level - the contained level in the AIS and LCK frames