Interlogix NS3550-8T-2S User Manual - Manual (Page 233)

User’s Manual of NS3550-8T-2S
233
 State This column shows the current state of the port as seen from the Limit Control's
point of view. The state takes one of four values:
Disabled
: Limit Control is either globally disabled or disabled on the port.
Ready : The limit is not yet reached. This can be shown for all actions.
Limit Reached : Indicates that the limit is reached on this port. This state can
only be shown if Action is set to None or Trap.
Shutdown
: Indicates that the port is shut down by the Limit Control module. This
state can only be shown if Action is set to Shutdown or Trap & Shutdown.
 Reopen Button If a port is shutdown by this module, you may reopen it by clicking this button,
which will only be enabled if this is the case. For other methods, refer to
Shutdown
in the Action section.
Note, that clicking the reopen button causes the page to be refreshed, so
non-committed changes will be lost.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
: Click to refresh the page. Note that non-committed changes will be lost.