Interlogix NS3550-8T-2S User Manual - Manual (Page 259)

User’s Manual of NS3550-8T-2S
259
 Name Name (residence and office occupant) - Example: Flemming Jahn
 Zip code Postal/zip code - Example: 2791
 Building Building (structure) - Example: Low Library
 Apartment Unit (Apartment, suite) - Example: Apt 42
 Floor Floor - Example: 4
 Room no. Room number - Example: 450F
 Place type Place type - Example: Office
 Postal community
name
Postal community name - Example: Leonia
 P.O. Box Post office box (P.O. BOX) - Example: 12345
 Additional code Additional code - Example: 1320300003
Emergency Call Service
Emergency Call Service (e.g. E911 and others), such as defined by TIA or NENA.
Object Description
 Emergency Call
Service
Emergency Call Service ELIN identifier data format is defined to carry the ELIN
identifier as used during emergency call setup to a traditional CAMA or ISDN
trunk-based PSAP. This format consists of a numerical digit string, corresponding
to the ELIN to be used for emergency calling.
Policies
Network Policy Discovery enables the efficient discovery and diagnosis of mismatch issues with the VLAN configuration, along
with the associated Layer 2 and Layer 3 attributes, which apply for a set of specific protocol applications on that port. Improper
network policy configurations are a very significant issue in VoIP environments that frequently result in voice quality degradation
or loss of service.
Policies are only intended for use with applications that have specific 'real-time’ network policy requirements, such as interactive
voice and/or video services.
The network policy attributes advertised are:
1. Layer 2 VLAN ID (IEEE 802.1Q-2003)
2. Layer 2 priority value (IEEE 802.1D-2004)
3. Layer 3 Diffserv code point (DSCP) value (IETF RFC 2474)
This network policy is potentially advertised and associated with multiple sets of application types supported on a given port.
The application types specifically addressed are:
1. Voice
2. Guest Voice
3. Softphone Voice
4. Video Conferencing
5. Streaming Video
6. Control / Signaling (conditionally support a separate network policy for the media types above)
A large network may support multiple VoIP policies across the entire organization, and different policies per application type.
LLDP-MED allows multiple policies to be advertised per port, each corresponding to a different application type. Different ports
on the same Network Connectivity Device may advertise different sets of policies, based on the authenticated user identity or
port configuration.
It should be noted that LLDP-MED is not intended to run on links other than between Network Connectivity Devices and
Endpoints, and therefore does not need to advertise the multitude of network policies that frequently run on an aggregated link
interior to the LAN.
Object Description
 Delete Check to delete the policy. It will be deleted during the next save.
 Policy ID ID for the policy. This is auto generated and shall be used when selecting the
polices that shall be mapped to the specific ports.