Interlogix NS3550-8T-2S User Manual - Manual (Page 460)

User’s Manual of NS3550-8T-2S
460
6.27 Ethernet Protection Switching Command
EPS Create
Description:
EPS create.
Syntax:
EPS create [] [domport|dompath|domservice|dommpls] [1p1|1f1] [] [] []
[][] [enable|disable]
Parameters:
: Instance number
domport|dompath|domservice|dommpls : Flow domain
1p1|1f1
: EPS architecture
: Working flow instance number
: Protecting flow instance number
: Working MEP instance number
: Protecting MEP instance number
: APS MEP instance number
enable|disable : enable/disable protection
EPS Config
Description:
EPS config operation.
Syntax:
EPS config [] [aps|noaps] [revert|norevert] [unidir|bidir]
[w0s|w10s|w30s|w1m|w5m|w12m][h0s|h100ms|h500ms|h1s|h2s|h5s|h10s]
Parameters:
: Instance number
aps|noaps : APS enable/disable
revert|norevert
: Revertive enable/disable
unidir|bidir
: Unidirectional or bidirectional switching
w0s|w10s|w30s|w1m|w5m|w12m
: Wait to restore timer value
h0s|h100ms|h500ms|h1s|h2s|h5s|h10s
: Hold off timer value
EPS Command
Description:
EPS command set operation.
Syntax:
EPS command [] [clear|lockout|forced|manualp|manualw|exercise|freeze|lockoutlocal]
Parameters:
: Instance number
clear|lockout|forced|manualp|manualw|exercise|freeze|lockoutlocal : EPS protection command type - clear is 'no
command active'
EPS State
Description: