Interlogix NS3550-8T-2S User Manual - Manual (Page 220)

User’s Manual of NS3550-8T-2S
220
State - Shows the state of the server. It takes one of the
following values:
Disabled
: The selected server is disabled.
Not Ready : The server is enabled, but IP
communication is not yet up and running.
Ready
: The server is enabled, IP communication is
up and running, and the RADIUS module is ready to
accept access attempts.
Dead (X seconds left)
: Access attempts were made
to this server, but it did not reply within the configured
timeout. The server has temporarily been disabled,
but will get re-enabled when the dead-time expires.
The number of seconds left before this occurs is
displayed in parentheses. This state is only reachable
when more than one server is enabled.
Round-Trip
Time radiusAuthClient
ExtRoundTripTim
e The time interval (measured in milliseconds) between
the most recent Access-Reply/Access-Challenge and
the Access-Request that matched it from the RADIUS
authentication server. The granularity of this
measurement is 100 ms. A value of 0 ms indicates
that there hasn't been round-trip communication with
the server yet.