Interlogix NS3550-8T-2S User Manual - Manual (Page 178)

User’s Manual of NS3550-8T-2S
178

QCE# Indicates the index of QCE.
31. Frame Type Indicates the type of frame to look for incomming frames. Possible frame types
are:

Any : The QCE will match all frame type.

Ethernet : Only Ethernet frames (with Ether Type 0x600-0xFFFF) are
allowed.

LLC : Only (LLC) frames are allowed.

SNAP : Only (SNAP) frames are allowed.

IPv4 : The QCE will match only IPV4 frames.

IPv6 : The QCE will match only IPV6 frames.
32. Port Indicates the list of ports configured with the QCE
33. Action Indicates the classification action taken on ingress frame if parameters
configured are matched with the frame's content.
There are three action fields: Class, DPL and DSCP.

Class : Classified QoS Class; if a frame matches the QCE it will be put
in the queue.

DPL : Drop Precedence Level; if a frame matches the QCE then DP
level will set to value displayed under DPL column.

DSCP : If a frame matches the QCE then DSCP will be classified with
the value displayed under DSCP column.

Conflict
Displays QCE status. It may happen that resources required to add a QCE may
not available, in that case it shows conflict status as 'Yes', otherwise it is always
'No'.Please note that conflict can be resolved by releaseing the resource required
by the QCE and pressing 'Refresh' button.
Buttons
: Select the QCL status from this drop down list.
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Click to release the resources required to add QCL entry, incase conflict status for any QCL entry is 'yes'.
: Click to refresh the page immediately.