Interlogix NS3550-8T-2S User Manual - Manual (Page 471)

User’s Manual of NS3550-8T-2S
471
Syntax:
Erps configuration [] [statistics|clear]
Parameters:
: protection group id 1 - 64
statistics|clear : ERPS statistics
6.30 PTP Command
PTP Configuration
Description:
Set or show PTP configuration.
Syntax:
PTP Configuration []
Parameters:
: Clock instance number [0…3]
Default Setting:
disable
PTP PortState
Description:
Set or show PTP port state.
Syntax:
PTP PortState [] [enable|disable|internal]
Parameters:
: Clock instance number [0…3]
: Port list or “all”, default: All ports
Enable : Enable PTP port.
Disable : Disable PTP port.
Internal : Enable PTP port as internal (in a distributed environment)
Default Setting:
Show actual port state
PTP ClockCreate
Description:
Create or show a PTP clock instance data..
Syntax:
PTP ClockCreate [] [] [] [] [] [] [] []
Parameters:
: clock instance number [0..3]
: The devtype parameter takes the following values:
ord : Ordinary/Boundary clock
p2p : Peer-to-peer transparent clock
e2e : End-to-end transparent clock
mst : Master only clock
slv : Slave only clock
(default: Show actual init parameters)
: The twostep parameter takes the following values:
true : Follow-up messages are used
false : No follow-up messages are used
: The protocol parameter takes the following values:
ethernet : The clock uses multicast Ethernet protocol
ip4multi : The clock uses IPv4 multicast protocol
ip4uni : The clock uses IPv4 unicast protocol
Note: IPv4 unicast protocol only works in Master only and Slave only clocks
See parameter