Allied Telesis AT-9000 Series - Manual (Page 951)

AT-9000 Switch Command Line User’s Guide
923
SHOW AUTH-MAC INTERFACE
Syntax
show auth-mac interface port
Parameters
port
Specifies a port. You can display more than one port at a time.
Modes
Privileged Exec mode
Description
Use this command to display the parameter settings of the authenticator
ports. This command is equivalent to “SHOW DOT1X INTERFACE” on
page 928. An example is shown in Figure 158.
Figure 158. SHOW AUTH-MAC INTERFACE Command
Example
This example displays the parameter settings of the authenticator port:
awplus# show auth-mac interface port1.0.1-port1.0.4
Authentication Info for interface port1.0.2
portEnabled: Enabled - portControl: Auto
portStatus: Unknown
reAuthenticate: Enabled
reAuthPeriod: 3600
PAE: quietPeriod: 60 - maxReauthReq: 2 - txPeriod: 30
BE: suppTimeout: 30 - serverTimeout: 30
CD: adminControlledDirections: both
guestVlan: Enabled
dynamicVlanCreation: None
hostMode: Single-Suppliant
dot1x: Enabled
protocolVersion: 1
authMac: Disabled
reAuthRelearning Disabled