Allied Telesis AT-9000 Series - Manual (Page 274)

Chapter 12: Power Over Ethernet Commands
246
SHOW POWER-INLINE
Syntax
show power-inline
Parameter
None
Mode
Privileged Exec mode
Description
Use this command to display operational information about PoE. An
example is shown in Figure 60. The fields are described in Table 23 on
page 247.
Figure 60. SHOW POWER-INLINE Command
PoE Status:
Nominal Power: 490W
Power Allocated: 346.0W
Actual Power Consumption: 151.0W
Operational Status: On
Power Usage Threshold: 80% (392W)
PoE Interface:
Interface Admin Pri Oper Power(mW) DeviceClassMax(mW)
port1.0.1 Enabled Low Powered 3840 n/a1 4000 [C]
port1.0.2 Enabled High Powered 6720 n/a2 7000 [C]
port1.0.3 Enabled Low Powered 14784 n/a3 15400 [C]
port1.0.4 Enabled Crit Powered 14784 n/a3 15400 [C]
port1.0.5 Enabled Crit Powered 3840 n/a1 4000 [C]
port1.0.6 Enabled High Powered 6720 n/a2 7000 [C]
port1.0.7EnabledLowPowered14784n/a315400 [C]