Allied Telesis AT-9000 Series - Manual (Page 304)

Chapter 14: IPv4 and IPv6 Management Address Commands
276
IP ADDRESS DHCP
Syntax
ip address dhcp
Parameters
None
Mode
VLAN Interface mode
Description
Use this command to assign the switch an IPv4 management address
from a DHCP server. This command activates the DHCP client, which
automatically queries the network for a DHCP server. The client also
queries for a DHCP server whenever you reset or power cycle the switch.
You must perform this command from the VLAN Interface mode of the
VLAN to which you want to assign the address.
The switch must have a management IPv4 address to support the
features listed in Table 26 on page 258. The switch can have only one
IPv4 address, and it must be assigned to the VLAN from which the switch
is to communicate with the management devices (such as Telnet
workstations and syslog servers). The VLAN must already exist on the
switch.
To manually assign the switch an IPv4 address, refer to “IP ADDRESS” on
page 274.
Note
You cannot assign the switch a dynamic IPv6 address from a DHCP
server. An IPv6 management address must be assigned manually
with “IPV6 ADDRESS” on page 280.
Confirmation Commands
“SHOW IP INTERFACE” on page 289 and “SHOW IP ROUTE” on
page 290