Allied Telesis AT-9000 Series - Manual (Page 524)

Chapter 33: Event Log Commands
496
SHOW LOG CONFIG
Syntax
show log config
Parameters
None
Modes
Privileged Exec mode
Description
Use this command to display the configuration of the event log.
awplus# show log config
Figure 96. SHOW LOG CONFIG Command
The fields in the display are described here:
This command is also used to view the configuration of the syslog client.
For information, refer to “SHOW LOG CONFIG” on page 511 in Chapter
35, “Syslog Client Commands” on page 507.
Example
The following command displays the configuration of the event log:
awplus# show log config
Table 54. SHOW LOG CONFIG Command
Field Description
Level The severity levels of the messages to be
stored in the log. The default is level 6,
Informational, and higher. The levels are
defined in Table 51 on page 489.
Program The software module messages to be
stored in the log. The modules are listed
in Table 53 on page 494. The default is all
modules.
Message Text Text that identifies the messages to be
stored in the log.