Allied Telesis AT-9000 Series - Manual (Page 944)

Chapter 61: 802.1x Port-based Network Access Control Commands
916
DOT1X TIMEOUT TX-PERIOD
Syntax
dot1x timeout tx-period value
Parameters
value
Sets the number of seconds an authenticator port waits for a
response to an EAP-request/identity frame from a client before
retransmitting the request. The default value is 30 seconds. The
range is 1 to 65,535 seconds.
Mode
Port Interface mode
Description
Use this command to set the amount of time that an authenticator port on
the switch waits for a reply from a client to an EAP-request/identity frame.
If no reply is received, it retransmits the frame.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 923 or “SHOW DOT1X
INTERFACE” on page 928
Example
This example sets the timeout period on authenticator ports 15 and 19 to
40 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15,port1.0.19
awplus(config-if)# dot1x timeout tx-period 40