Allied Telesis AT-9000 Series - Manual (Page 1280)

Chapter 75: Quality of Service (QOS) Commands
1252 Section X: Network Management
SHOW MLS QOS MAPS COS-QUEUE
Syntax
show mls qos maps cos-queue interface port
Parameters
port Specifies the port to display. You can view only one port at
a time.
Mode
Privileged Exec mode
Description
Use this command to display the mappings of CoS priority values to port
egress queues. An example of the information is shown in Figure 205.
Figure 205. SHOW MLS QOS MAPS COS-QUEUE Command
The CoS values in the first line are matched with the egress queue
assignments in the second line. For example, in Figure 205 of port 1,
packets with CoS 0 are placed in egress queue 2, packets with CoS 1 are
placed in egress queue 0, and so on.
The mappings of CoS priorities and egress queues are set with “MLS
QOS MAP COS-QUEUE” on page 1238.
Example
This example display the mappings of CoS priority values to port egress
queues for port 17
awplus# show mls qos maps cos-queue interface port1.0.17
Interface port1.0.1:
COS-TO-QUEUE-MAP:
COS : 0 1 2 3 4 5 6 7
----------------------------
QUEUE : 2 0 1 3 4 5 6 7