Allied Telesis AT-9000 Series - Manual (Page 705)

AT-9000 Switch Command Line User’s Guide
677
SPANNING-TREE MSTP ENABLE
Syntax
spanning-tree mstp enable
Parameters
None
Mode
Global Configuration mode
Description
Use this command to designate MSTP as the active spanning tree
protocol on the switch. After activating the protocol, you can enable or
disable the spanning tree protocol and set the switch or port parameters.
MSTP is active on the switch only after you have designated it as the
active spanning tree with this command and enabled it with “SPANNING-
TREE MST CONFIGURATION” on page 678.
Only one spanning tree protocol, STP, RSTP, or MSTP can be active on
the switch.
Confirmation Command
“SHOW SPANNING-TREE” on page 669
Example
This example enables MSTP on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mstp enable