Allied Telesis AT-9000 Series - Manual (Page 880)

Chapter 59: MAC Address-based Port Security Commands
852
SHOW PORT-SECURITY INTERFACE
Syntax
show port-security interface port
Parameters
port
Specifies the port whose security mode settings you want to view.
You can display more than one port at a time.
Mode
Privileged Exec mode
Description
Use this command to display the security settings of the ports on the
switch. An example of the information is shown in Figure 150.
Figure 150. SHOW PORT-SECURITY INTERFACE Command
The fields are described in Table 85.
Table 85. SHOW PORT-SECURITY INTERFACE Command
Field Description
Port Port number.
Security Enabled The current status of MAC address-based
security on the port. The security is active
if the status is Yes and inactive if the
status is No. To activate or deactivate
security on the port, refer to
“SWITCHPORT PORT-SECURITY” on
page 857 or “NO SWITCHPORT PORT-
SECURITY” on page 850, respectively.
Port Security Configuration - Port1.0.15
----------------------------------------------
Security Enabled
: YES
Port Status : ENABLED
Violation Mode : PROTECT
Aging : NO
Maximum MAC Addresses : 0
Current Learned Addresses : 0
Lock Status
: UNLOCKED
Security Violation Count : 0