Allied Telesis AT-9000 Series - Manual (Page 1316)

Chapter 79: Telnet Server Commands
1288
NO SERVICE TELNET
Syntax
no service telnet
Parameters
None
Mode
Global Configuration mode
Description
Use this command to disable the Telnet server on the switch. You cannot
remotely manage the switch with a remote Telnet client when the server is
disabled. The default setting for the Telnet server is enabled.
Note
Your management session ends if you disable the server from a
remote Telnet session. To resume managing the unit, establish a
local management session or remote web browser session. If the
maximum number of manager sessions on the switch is set to one,
you must wait for the console timer on the switch to expire before
starting a new management session. The default setting for the
console timer is 10 minutes.
Confirmation Command
“SHOW TELNET” on page 1290
Example
This example disables the Telnet server:
awplus> enable
awplus# configure terminal
awplus(config)# no service telnet