Allied Telesis AT-9000 Series - Manual (Page 1227)

1199
Chapter 74
ACL Commands
The Access Control List (ACL) commands are summarized in Table 143
and described in detail within the chapter.
Table 143. Access Control List Commands
Command Mode Description
“ACCESS-CLASS” on page 1201 Virtual Terminal
Line mode Assigns an ACL to a VTY line.
“ACCESS-GROUP” on page 1203 Port Interface Adds IP ACLs to ports.
“ACCESS-LIST (MAC Address)” on
page 1205 Global
Configuration Creates ACLs that identify packets
based on source and destination MAC
addresses.
“ACCESS-LIST ICMP” on page 1208 Global
Configuration Creates ACLs that identify packets
based on ICMP source and
destination IP addresses.
“ACCESS-LIST IP” on page 1211 Global
Configuration Creates ACLs that filter packets based
on source and destination IP
addresses.
“ACCESS-LIST PROTO” on
page 1215 Global
Configuration Creates ACLs that identify packets
based on protocol numbers and
source and destination IP addresses.
“ACCESS-LIST TCP” on page 1220 Global
Configuration Creates access control lists that filter
ingress packets based on TCP port
numbers.
“ACCESS-LIST UDP” on page 1224 Global
Configuration Creates access control lists that
identify ingress packets based on
UDP port numbers.
“MAC ACCESS-GROUP” on
page 1228 Global
Configuration Adds MAC address ACLs to ports on
the switch.
“NO ACCESS-LIST” on page 1229 Global
Configuration Deletes ACLs from the switch.
“NO ACCESS-GROUP” on page 1230 Port Interface Removes ACLs from ports on the
switch.