Allied Telesis AT-9000 Series - Manual (Page 1273)

AT-9000 Switch Command Line User’s Guide
Section X: Network Management 1245
MLS QOS TRUST COS
Syntax
mls qos trust cos
Parameters
None.
Mode
Port Interface mode
Description
Use this command to configure ports to use the CoS priorities in ingress
packets to determine the appropriate queues on the egress ports to store
the packets.
Note
QoS must be enabled on the switch before you can use this
command.
Use the NO form of this command to stop ports from using the CoS
priorities in ingress packets to determine the egress queues.
Confirmation Command
“SHOW MLS QOS INTERFACE” on page 1249
Example
This example configures ports 1 and 2 to use the CoS values of the
ingress packets when directing packets to the queues on the egress ports:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.2
awplus(config-if)# mls qos trust cos