Allied Telesis AT-9000 Series - Manual (Page 1271)

AT-9000 Switch Command Line User’s Guide
Section X: Network Management 1243
MLS QOS SET COS
Syntax
mls qos set cos priority
Parameters
priority Specifies a Class of Service (CoS) priority level of 0, lowest
priority, to 7, highest priority. You can specify just one
priority level.
Mode
Port Interface mode
Description
Use this command to remark all egress packets on a port with the
specified CoS value.
Use the NO form of this command to remove remark CoS values from
ports.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 130
Example
This example configures port 12 to add or change the CoS priority in all
egress packets to 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.12
awplus(config-if)# mls qos set cos 5
This example removes the remark CoS value from port 1:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1
awplus(config-if)# no mls qos set cos