Allied Telesis AT-9000 Series - Manual (Page 255)

227
Chapter 12
Power Over Ethernet Commands
The Power over Ethernet (PoE) commands are summarized in Table 22.
These commands are only supported on the PoE switches.
Table 22. Power over Ethernet Commands
Command Mode Description
“CLEAR POWER-INLINE
COUNTERS INTERFACE” on
page 229 Privileged Exec Clears the PoE event counters on the
ports.
“NO POWER-INLINE ALLOW-
LEGACY” on page 230 Port Interface Configures ports to deny power to
legacy powered devices (PDs).
“NO POWER-INLINE DESCRIPTION”
on page 231 Port Interface Deletes the PD descriptions.
“NO POWER-INLINE ENABLE” on
page 232 Port Interface Disables PoE on the ports.
“NO POWER-INLINE MAX” on
page 233 Port Interface Restores a port’s power limit to the
default value.
“NO POWER-INLINE PRIORITY” on
page 234 Port Interface Restores a port’s priority setting to the
default Low level.
“NO POWER-INLINE USAGE-
THRESHOLD” on page 235 Global
Configuration Resets the power usage threshold to
the default 80%.
“NO SERVICE POWER-INLINE” on
page 236 Global
Configuration Disables PoE on all of the ports on the
switch.
“NO SNMP-SERVER ENABLE TRAP
POWER-INLINE” on page 237 Global
Configuration Disables the SNMP power-inline trap.
“POWER-INLINE ALLOW-LEGACY”
on page 238 Port Interface Configures a port to support legacy
PDs.
“POWER-INLINE DESCRIPTION” on
page 239 Port Interface Adds a PD description to a port.
“POWER-INLINE ENABLE” on
page 240 Port Interface Enables PoE on a port.
“POWER-INLINE MAX” on page 241 Port Interface Specifies the power limit of a port.