Allied Telesis AT-9000 Series - Manual (Page 916)

Chapter 60: 802.1x Port-based Network Access Control
888
Displaying Authenticator Ports
To view the settings of authenticator ports on the switch, use the SHOW
DOT1X INTERFACE or SHOW AUTH-MAC INTERFACE command in the
Privileged Exec mode. Both commands display the same information. This
example displays the authenticator settings for port 2:
awplus# show dot1x interface port1.0.2
Figure 156 is an example of what you will see.
Figure 156. SHOW DOT1X INTERFACE Command
Authentication Info for interface port1.0.2
portEnabled: Enabled - portControl: Auto
portStatus: DOWN
reAuthenticate: Disabled
reAuthPeriod: 3600
PAE: quietPeriod: 60 - maxReauthReq: 2 - txPeriod: 30
BE: suppTimeout: 30 - serverTimeout: 30
CD: adminControlledDirections: both
guestVlan: Disabled
DynamicVlanCreation: None
hostMode: Single-Host
dot1x: Enabled
protocolVersion: 1
authMac: Disabled