Allied Telesis AT-9000 Series - Manual (Page 81)

AT-9000 Switch Command Line User’s Guide
53
Saving Your Configuration Changes
To permanently save your changes to the parameter settings on the
switch, you must update the active boot configuration file. This is
accomplished with either the WRITE command or the COPY RUNNING-
CONFIG STARTUP-CONFIG command, both of which are found in the
Privileged Exec mode. When you enter either of these commands, the
switch copies its running configuration into the active boot configuration
file for permanent storage.
To update the active configuration file, enter:
awplus# write
or
awplus# copy running-config startup-config
Note
Parameter changes that are not saved in the active boot
configuration file are discarded when the switch is powered off or
reset.