Allied Telesis AT-9000 Series - Manual (Page 861)

AT-9000 Switch Command Line User’s Guide
Section III: File System 833
PLATFORM VLAN-STACKING-TPID
Syntax
platform vlan-stacking-tpid tpid
Parameters
tpid Specifies the Tag Protocol Identifier (TPID) value that
applies to all frames carrying double tagged VLANs.
The range is 0x0 to 0xFFFF. The switch can have just
one TPID value. The value must be entered in
hexadecimal format.
Mode
Global Configuration mode
Description
Use this command to specify the Tag Protocol Identifier (TPID) value that
applies to all frames that are carrying double tagged VLANs. All nested
VLANs must use the same TPID value.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 130 or “SHOW VLAN VLAN-
STACKING” on page 834
Example
This example sets the TPID to 0x9000:
awplus> enable
awplus# configure terminal
awplus(config)# platform vlan-stacking-tpid 9000