Allied Telesis AT-9000 Series - Manual (Page 1272)

Chapter 75: Quality of Service (QOS) Commands
1244 Section X: Network Management
MLS QOS SET DSCP
Syntax
mls qos set dscp priority
Parameters
priority Specifies a DSCP priority level of 0, lowest priority, to 63,
highest priority. You can specify just one priority level.
None.
Mode
Port Interface mode
Description
Use this command to remark all egress packets on a port with the
specified DSCP value.
Use the NO form of this command to remove remark DSCP values from
ports.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 130
Example
This example configures port 3 to add or change the DSCP value in all
egress packets to 27:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# mls qos set dscp 27
This example removes the remark DSCP value from port 23:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23
awplus(config-if)# no mls qos set dscp