Allied Telesis AT-9000 Series User Manual
Page 160
Chapter 8: Basic Switch Management Commands
132
Example
The following example displays the switch information:
awplus# show switch
Active Spanning Tree
version
The active spanning tree protocol on the
switch. The protocol can be STP, RSTP,
or MSTP. The active spanning tree
protocol is set with “SPANNING-TREE
MODE STP” on page 598, “SPANNING-
TREE MODE RSTP” on page 634, and
“SPANNING-TREE MODE MSTP” on
page 676.
Console Disconnect Timer
Interval
The current setting of the console timer.
The switch uses the console timer to end
inactive management sessions. The
switch ends management sessions if they
are inactive for the length of the timer. To
set the timer, refer to “EXEC-TIMEOUT”
on page 114.
Telnet Server Status
The status of the Telnet server. The switch
can be remotely managed from a Telnet
client on your network when the server is
enabled. When the server is disabled, the
switch cannot be remotely managed with
a Telnet client. To configure the Telnet
client, refer to “SERVICE TELNET” on
page 1289 and “NO SERVICE TELNET”
on page 1288.
MAC Address Aging Time
The current setting of the aging timer,
which the switch uses to delete inactive
dynamic MAC addresses from the MAC
address table. To set this value, refer to
“MAC ADDRESS-TABLE AGEING-TIME”
on page 328.
Table 9. SHOW SWITCH Command (Continued)
Parameter
Description