Allied Telesis AT-9000 Series - Manual (Page 264)

Chapter 12: Power Over Ethernet Commands
236
NO SERVICE POWER-INLINE
Syntax
no service power-inline
Parameters
None
Mode
Global Configuration mode
Description
Use this command to disable PoE on the switch. The ports do not transmit
power to the PDs when PoE is disabled, but they do forward network
traffic. The default setting for PoE is enabled.
Confirmation Commands
“SHOW POWER-INLINE” on page 246
“SHOW POWER-INLINE INTERFACE” on page 251
“SHOW POWER-INLINE INTERFACE DETAIL” on page 252
Example
This example disables PoE on the switch:
awplus> enable
awplus# configure terminal
awplus(config)# no service power-inline