Allied Telesis AT-9000 Series - Manual (Page 930)

Chapter 61: 802.1x Port-based Network Access Control Commands
902
AUTH TIMEOUT REAUTH-PERIOD
Syntax
auth timeout reauth-period value
Parameters
reauth-period
Specifies the time interval that an authenticator port requires a
client to reauthenticate. The range is 1 to 65,535 seconds. The
default value is 3600 seconds.
Mode
Port Interface mode
Description
Use this command to specify the time interval for reauthentication of
clients on an authenticator port. Reauthentication must be enabled on a
authenticator port for the timer to work. Reauthentication on a port is
activated with “AUTH REAUTHENTICATION” on page 900.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 923 or “SHOW DOT1X
INTERFACE” on page 928
Example
This example activates reauthentication on port 16 and sets the
reauthentication interval to 12 hours:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.16
awplus(config-if)# auth reauthentication
awplus(config-if)# auth timeout reauth-period 43200