Allied Telesis AT-9000 Series - Manual (Page 919)

891
Chapter 61
802.1x Port-based Network Access
Control Commands
The 802.1x port-based network access control commands are
summarized in Table 87 and described in detail within the chapter.
Table 87. 802.1x Port-based Network Access Control Commands
Command Mode Description
“AAA AUTHENTICATION DOT1X
DEFAULT GROUP RADIUS” on
page 894 Global
Configuration Activates 802.1x port-based network
access control on the switch.
“AUTH DYNAMIC-VLAN-CREATION”
on page 895 Port Interface Sets the VLAN assignments of
authenticator ports according to the
client accounts on the authentication
server.
“AUTH GUEST-VLAN” on page 897 Port Interface Specifies the VIDs of guest VLANs of
authenticator ports.
“AUTH HOST-MODE” on page 898 Port Interface Sets the operating modes on
authenticator ports.
“AUTH REAUTHENTICATION” on
page 900 Port Interface Activates reauthentication on the
authenticator ports.
“AUTH TIMEOUT QUIET-PERIOD” on
page 901 Port Interface Sets the number of seconds that
authenticator ports wait after a failed
authentication before accepting
authentication requests again.
“AUTH TIMEOUT REAUTH-PERIOD”
on page 902 Port Interface Specifies the time interval for
reauthentication of clients on an
authenticator port.
“AUTH TIMEOUT SERVER-
TIMEOUT” on page 903 Port Interface Sets the length of time the switch
waits for a response from the
authentication server.
“AUTH TIMEOUT SUPP-TIMEOUT”
on page 904 Port Interface Sets the switch-to-client
retransmission time for EAP-request
frames on authenticator ports.
“AUTH-MAC ENABLE” on page 905 Port Interface Activates MAC address-based
authentication on authenticator ports.