Allied Telesis AT-9000 Series - Manual (Page 262)

Chapter 12: Power Over Ethernet Commands
234
NO POWER-INLINE PRIORITY
Syntax
no power-inline priority
Parameters
None
Mode
Port Interface mode
Description
Use this command to restore the default Low priority setting to the ports.
Confirmation Commands
“SHOW POWER-INLINE” on page 246
“SHOW POWER-INLINE INTERFACE” on page 251
“SHOW POWER-INLINE INTERFACE DETAIL” on page 252
Example
This example restores the default Low priority level to port 20:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.20
awplus(config-if)# no power-inline priority