Allied Telesis AT-9000 Series - Manual (Page 777)

749
Chapter 50
GARP VLAN Registration Protocol
Commands
The GARP VLAN registration protocol commands are summarized in
Table 73 and described in detail within the chapter.
Table 73. GARP VLAN Registration Protocol Commands
Command Mode Description
“CONVERT DYNAMIC VLAN” on
page 751 VLAN
Configuration Converts dynamic GVRP VLANs and
port assignments to static.
“GVRP APPLICANT STATE ACTIVE”
on page 752 Global
Configuration Enables GIP on the switch.
“GVRP APPLICANT STATE
NORMAL” on page 753 Global
Configuration Disables GIP.
“GVRP ENABLE” on page 754 Global
Configuration Enables GVRP.
“GVRP REGISTRATION” on
page 755 Port Interface Set a port’s GVRP status.
“GVRP TIMER JOIN” on page 756 Global
Configuration Sets the GARP Join Timer.
“GVRP TIMER LEAVE” on page 757 Global
Configuration Sets the GARP Leave Timer.
“GVRP TIMER LEAVEALL” on
page 758 Global
Configuration Sets the GARP Leave All timer.
“NO GVRP ENABLE” on page 759 Global
Configuration Disables GVRP on the switch.
“NO GVRP TIMER JOIN” on page 760 Global
Configuration
Disables the GARP Join Timer.
“NO GVRP TIMER LEAVE” on
page 761 Global
Configuration Disables the GARP Leave Timer.
“NO GVRP TIMER LEAVEALL” on
page 762 Global
Configuration Disables the GARP Leave All timer.
“PURGE GVRP” on page 763 Global
Configuration Disables GVRP on the switch and
returns the timers to their default
values.