Allied Telesis AT-9000 Series - Manual (Page 360)

Chapter 18: MAC Address Table Commands
332
NO MAC ADDRESS-TABLE STATIC
Syntax
no mac address-table static macaddress forward|discard
interface port [vlan vlan-name | vid ]
Parameters
macaddress
Specifies the static unicast address you want to delete from the
switch’s MAC address table. The address must be specified in
either one of the following formats: xx:xx:xx:xx:xx:xx or
xxxx.xxxx.xxxx
forward
Forwards packets containing the designated source MAC address.
discard
Discards packets containing the designated source MAC address.
port
Specifies the port(s) where the MAC address is assigned.
vlan-name
Specifies the name of the VLAN where the node of the MAC
address is a member. This parameter is optional.
vid
Specifies the ID number of the VLAN where the node of the MAC
address is a member. You can omit this parameter when removing
addresses from the Default_VLAN.
Mode
Global Configuration mode
Description
Use this command to delete dynamic or static unicast addresses from the
switch’s MAC address table. This command performs the same function
as “CLEAR MAC ADDRESS-TABLE” on page 326.
Note
You cannot delete the switch’s MAC address, an STP BPDU MAC
address, or a broadcast address from the table.