Allied Telesis AT-9000 Series - Manual (Page 297)

AT-9000 Switch Command Line User’s Guide
269
Displaying an
IPv6
Management
Address and
Default Gateway
There are two commands for displaying a management IPv6 address and
default gateway. If the switch has both an IPv6 address and default
gateway, you can display both of them with the SHOW IPV6 ROUTE
command, in the Privileged Exec mode, as shown here:
awplus# show ipv6 route
Here is an example of the information. The default route is displayed first,
followed by the management address.
Figure 66. SHOW IPV6 ROUTE Command
Another way to display just the management address is with the SHOW
IPV6 INTERFACE command, shown here:
awplus# show ipv6 interface
Here is an example of the information from the command.
Figure 67. SHOW IPV6 INTERFACE Command
The columns are defined in Table 29 on page 292.
IPv6 Routing Table
Codes: C - connected, S - static
S 0:0:0:0:0:0:0:0/0 via 832a:5821:b34a:0:0:0:187:14, vlan4-0
C 832a:5821:b34a:0:0:0:187:95a/64 via ::, vlan4-0
Interface IPv6-Address Status Protocol
VLAN3-0 832a:5821:b34a:0:0:0:187:95a/64 admin up down